Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktinformation
FTVOGUE ZVS Treibermodul 5V-12V Induktionserwärmungs-Stromversorgungsmodul 120W Induktionsheizungsleiter mit Spule
1 x ZVS-Heizung Stromversorgungsmodul
1 x Heizspule
Josh thompson
Bewertet in Großbritannien am 4. September 2024
Product turned up faulty.
ian moutter
Bewertet in Großbritannien am 24. April 2024
Circuit is well made and device works well
K.Hackethal
Bewertet in Deutschland am 26. November 2023
Habe diesen Artikel zu Testzwecken erworben. Er kann pünktlich bei mir an. Ich habe ihn zusammen gebaut und an meinem Labornetzteil in Betrieb genommen. Er funktionierte zwei mal, dan kam aus den Transistoren magischer Rauch heraus und das Teil stellte seine Funktion ein, was verständlich ist. Schade ums des Geld und schade für noch mehr Elektromüll.
ledsam
Bewertet in Großbritannien am 17. Dezember 2023
Induction heating is fun, the magic of induction energy. this little unit works very well with small metal objects like 4mm nut & bolt. please use caution as metal objects will get hot and don't use near electronic devices. good build quality and easy to setup but needs instruction on how to use correctly this is why only 3 stars.
Ali
Bewertet in Großbritannien am 10. Dezember 2023
I got this mainly to experiment but since then it has also proven useful for model building on situations such as needing to heat a nail or similar up to create holes in plastic material.It comes with absolutely no instructions, you need to resist the urge to connect the coil to the terminals provided on the outside of the circuit. The coil itself gets hot very quickly and melts the terminals before you get to do anything useful with the heat produced. To avoid this the coil needs to be soldered directly onto the circuit board. There was obviously an attempt to explain this on the product listing, but the instructions weren't very clear at the time of this review. It is important to give breaks every now and then to let the coil and the circuit cool down, as the constant heat can put stress on components over extended use.I powered the device up using a 12V 10A lab power supply. It quickly heats whatever metallic object you extend inside the coil, however, don't expect things to go red-hot as shown in some videos. Still, it is useful for model making or similar hobbies.Needless to say, this is not a toy and any experiments must be conducted under adult supervision.Recommended for experimentation, if you have a soldering set available.
Produktempfehlungen