Ihr Warenkorb ist leer
Ihr Warenkorb ist leer "Zahnriemen GT2-Gürtel 6 mm breit 2 mm Pitch für Creality Ender 3 3 Pro Ender 3 V2 Ender3 K1 CR-10 Anycubic Kobra 2 Kobra Max CNC und andere 3D-Drucker (10M)
Typ: GT2 -Gürtel
GT2 6 mm Gürtelabent Messgeräte
Breite: 6mm
Form: Öffnen Sie den Timing -Gürtel
Packungsliste: GT2 -Gürtel für 3D -Drucker
"
steffen klöver
Bewertet in Deutschland am 31. Januar 2025
Alles top
Nick
Bewertet in Großbritannien am 19. Juni 2024
I've not installed this into a system yet, however from the look and feel this is a belt that's comparable to others I've used. The width is accurate (I measured 5.98mm), and I tested it against spare GT2 pulleys and it meshed fine.
Dawid
Bewertet in Deutschland am 17. Dezember 2024
Macht was es soll, reicht für 2 mal bei meinem Anycubic. Leider kommt es ohne den kupfer klemmen. Wenn man sich an die Anleitung hält ist auch die Montage Kinderleicht.
APOC286
Bewertet in Großbritannien am 14. Juli 2024
I got this as a spare belt, and I've not had to use it yet.However I can confirm the dimensions are correct, the teeth spacing lines up, and going by feel I can't tell any difference in stretchiness, hardness, or flexibility between this and a genuine Gates belt.The only real difference I could see, is in the reinforcement strands that run along the belt. This belt has fewer but much larger strands than the gates belts, whereas the Gates belts have far more numerous but much much smaller strands. In practise however I can't see there being much of a noticeable difference in the belts lifespan or performance due to this however though.
Produktempfehlungen
