Ihr Warenkorb ist leer
Ihr Warenkorb ist leer
This shutter louver bit has a cutting height of 1-1/4\" and a cutting depth of 1/4\". The overall length is 3-3/8\" and the shank is 1/2\"
Highlights:
- Create louver slats for window shutters
- Premium C3 micro-grain tungsten carbide blades for a sharper & longer lasting edge
- For use on table mount router
- Silver induction brazing for maximum strength and durability
- Manufactured with anti-kickback design to help prevent workshop mishaps
Item Includes:
1 Router Bit
Make functional plantation shutters with our louver slat router bits. This router bit give you the flexibility to create slats of almost any dimension with a single bit. Route all four edges of each slat to produce the tapered shape. Connect the louvers with a control arm for easy opening and closing.
john2459
Bewertet in den USA am5. März 2025
Great quality and price. Pleasantly surprised!
Customer
Bewertet in Großbritannien am 3. Mai 2024
Would recommend this cutter ideal for making shutter slats great product
Bedro
Bewertet in Großbritannien am 20. März 2024
Works well and does what it should. Very happy.
Customer
Bewertet in den USA am5. April 2023
Inexpensive and delivered quickly
That Know-it-all
Bewertet in den USA am8. Juni 2019
A very good bit, of maintained properly. This is a louvre bit so it gets a LOT of use for shutters or blinds. Even medium size windows require a LOT of louvres...times 4 passes for each louvre. My project needed 99 louvres, at 20” (51 cm) each, so I used 24” stock ( 2 1/2 x 3/4 stock Select Pine) cut in half lengthwise on a table saw (yes, two passes for every cut). First point: using your finish length add about 1” (2.5 cm) on each end of stock to accommodate entry and exit variations which are pronounced with this bit. The middle is good, but both ends are very sloppy. Support during cutting is very important. I used two pieces of same-thickness stock to form a guide - first piece next to fence to hold down the stock vertically, second layered on first but offset lower to hold the stock laterally along top half (not top edge - the edge changes with each pass) similar to a feather board. And I used a feather board at the bottom edge. Again, every louvre requires 4 passes - one or each edge. For me, 99 x 2 foot (61cm) x 4 passes equals nearly 800 feet of routing required. This bit is very good quality and is up to it... with proper maintenance. I removed and resharpened (600 and 1200 diamond cards) halfway through. More would have been better. But more importantly, if the finish starts to look bad, stop and retighten your bit chuck. Do not wait. I used a new Triton router and still had to retighten 6 or 8 times. Can’t stress this enough. The bit is very good - if there is a finish problem (and you can hear and see it) then look to retighten your chuck first. Finally, do check the bearing screw regularly after first sharpening (you have to remove to sharpen). Mine came completely off during use - my fault for not checking. Retighten regularly. Overall, a really high quality bit. For a specialty bit it gets a lot of use, but works great. Highly recommend.
Produktempfehlungen
99.51€
44 .99 € 44.99€
35.36€
16 .99 € 16.99€