Ihr Warenkorb ist leer
Ihr Warenkorb ist leerAuswahl der Firmware： 1. Marlin Firmware Configuration: 100k Formbot / Vivedino 3950 350C thermistor 4.7k pullup . 2. Klipper: NTC 100K MGB18-104F39050L32
Paolo C.
Bewertet in Deutschland am 11. April 2025
this thing is a bomb. i mounted on my zerog mercury and is and actual clone of the dragon hotend. it pushes filament like a champ at 600mm/s 12000 and didn't bat an eye. prints that would take 5h are now 2h thanks also to this monster and direct drive.If you are on a budget, defo take this.
Mr. W. Anthony
Bewertet in Großbritannien am 9. Juli 2024
This is an okay hotend that comes with a CHT clone nozzle. It prints PLA lovely but getting the heater to sustain the temps required to print ABS is a nightmare. It's sporadic when it struggles and Klipper will fail at the most random time in prints with a verify_heater error meaning the print fails.If you want a cheap hotend to throw on a printer and just print PLA I can't fault it, I wouldn't use it for anything else.
Florian Krügl
Bewertet in Deutschland am 8. Juli 2024
Drop in replacement for Dragon Hotend, lacks the flexibility regarding thermistor and heater cartridge. Hardware replacements are harder to find. Heating elements are a myth...
Viktor M.
Bewertet in Deutschland am 18. Januar 2024
An sich ist das echt eine sehr gute Erfindung, funktionierte einwandfrei. Plötzlich hat es eines Tages nicht mehr hoch geheizt und ist bei 200 Grad stehen geblieben, ging zurück
pendras jean marie
Bewertet in Frankreich am 15. Dezember 2024
ne pas acheté au bout de 3h d utilisation problème de fuite impossible de reglé ce problème
Maureen P.
Bewertet in Großbritannien am 4. Oktober 2023
I love the way this extruder does not block up like the cheaper one's, had a lot of trouble with other extruders jamming but this one is brilliant.
ColoradofromJames
Bewertet in den USA am25. Oktober 2023
I don’t write reviews. Usually I don’t care. This time it’s different. I’m disgusted by this garbage. TWO leaks! Nope. Going back. My money is better than this.
jared bean
Bewertet in den USA am16. Juni 2023
I really wanted to love this nozzle. It was great installing and getting set up. One 16 hour print in and the boot disintegrates...falls into pieces....and kills the print. Other than that. Great heatup. No major overshoot.
Produktempfehlungen
17.98€
8 .99 € 8.99€