Schnelle Lieferung, Anleitung zum Einbau ist gut verständlich, tut was er soll, auch wenn er nicht der günstigste ist

I have one of the NEVERCOLD large double door propane fridges in my 5th wheel. This fridge is super finicky and would not stay cold when outside temperatures got up above 95. I bought two of these fans and installed one in the upper vent blowing outward and one below blowing upward. It made a huge difference in my fridge performance. I can trust that my food won’t spoil in the fridge now!

Installed on top of cooling coils and the refrigerator now working great

Wir hatten die Lüfter bei 35grad im Einsatz.Seitdem brauchen wir unseren Absorber- Kühlschrank nur noch auf mittlere Leistung laufen lassen.Kühlt um einiges besser.Sehr Gut

Installed this fan setup on the top vent in front of the upper condenser and pushing the hot air out from the compartment. We now have temps (5 F) in the freezer that keeps frozen yogurt solid and making ice is not a problem. Also pop and beer very cold (32 F) in the fridge and are so happy. Also we can’t hear the fans running at all in the RV which is a plus. Thank you.

Ein muss für meinen Absorberkühlschrank.Leicht einzu bauen und die kühlleistung wird deutlich höher

I have Norcold 1210T refrigerator that struggles to hold cold at my desired 34-36°F during 90°F+ heat in direct sun. I ordered this fan set and was able to open my top fridge slide out vent panel and drop the remote and power wires down along the wall by flexing the baffle wood panel outward and working the cable to the far left past the the upper fins. I made sure to keep a hand on the fan power plug so that I did not drop it down as the fans are to be mounted on the top and blowing out of the panel.Once I got over to the far left, I was able to start working down by sort of bouncing the wires along with the remote used as a pendulum weight while my wife was below watching for success. Once I got the power/ground wires and remote down and she worked it all out the lower vent area, I simply needed to T-Tap into any two of the labeled 12V+/12V- wire pairs. I used the thermal safety switch (a recall add on for you guys with older 1210 fridges), T-Tapped on and connected the fan's power and ground and immediately was able to test that the wired remote had power. All good.Then I went up top again and used an oscillating tool to remove a large portion of the upper wood baffle panel so that the fans could sit back enough to re-install the upper vent panel. The fans themselves are hanging from the 2 upper clips on the fan assembly, the bottom is not attached. It is simply hanging there. So for going on the road, I will just go up and unplug ad remove the fans and tie the wire harness up so that it does not fall. It will take 2 minutes to remove. I guess if I cared, I could zip-tie the fans to the vent panel, but its not a big deal to me. You decide how you want to handle that.I wrapped the thermal sensor wire around the big round cylinder thing that is easily accessed in the lower panel, I made sure to wrap 3 turns with the end of the thermostat wire folded under the triple wrap and tucked under as I pulled it tight. This has been working perfectly and the fans come on quickly after the propane kicks on the heat the ammonia. I have been using the auto setting and I am holding tight on 32-34 degrees on setting 7 of 9 while in direct sun. I am happy to see my freezer box finally holding single digits with ease as well. I am seeing 4°F to 10°F in the freezer. I did not attempt to run the remote inside the camper body to the kitchen area, instead I tucked it on the left side of the outside lower vent where I dropped the harness down and can easily access it there is desired.I use the Amazon sourced fridge/freezer remote thermometer kit titled "AcuRite Digital Wireless Fridge and Freezer Thermometer with Alarm and Max/Min Temperature for Home" and it works flawlessly and we both love it. I bought it April of 2021 and have replaced the AA batteries 1 time. I do use Amazon Basics batteries and have had very good luck with them. I recommend that you check them out.Overall, I am very happy with this fan kit and would buy it again. I wish that the bracket kit were more adaptable to be capable of securing to my unique vent covers. But the ease of install and performance of the fans has me happy.

Funktioniert perfekt

Fan speed is not the strongest or fastest. Auto setting does not work well. Manual setting fan kick on a faster setting. The thermo sensor is worthless doesn't even detect temp or adjust speed of fan when it's cooler inside. My fridge temp did come down this helped. But I actual mounted the fan air flow to blow air inside the back of my fridge screen. To push air inside and up the roof vent. Made a huge different. My fridge is a dometic and is mounted on the side of my rv. Not in a slide out. I had the fan originally mounted to push air our of the screen and it did nothing for me but only raise the Temps even more my fridge would get up to 80 and 90 degrees. As of this morning my fridge is at a low 32 degrees and freezer 2. I had to move the climate probe plastic fin slider lower to lower the fridges temp. Got too cold.. so people. You want air pushing in and up the vent to create air flow.

Schnelle Lieferung. Die Ware ist absolut gut. Erster Urlaubstest war erfolgreich die Lüfter sind sehr leise und haben einen hohen Luftdurchsatz.

Wir haben leidvoll im Urlaub gemerkt dass ein eingebauter Absorber Kühlschrank unseres Campers nur dann funktionieren kann, wenn die warme Luft bei gleichzeitig warmer Außentemperatur nur funktionieren kann, wenn die Warmluft abgeführt wird. Und hier kommt das Ventilator Set ins Spiel, es sorgt für einen Durchzug und transportiert die warme Luft sofort durch das Lüftungsgitter nach draußen um Stauwärme zu verhindern.Nach Einbau haben wir direkt im nächsten Urlaub getestet (aussentemp 33 grad) und siehe da der Kühlschrank ist wieder deutlich kühler. Es machte bei uns rund 12 grad aus, finale Temperatur im Kühlschrank 12-14 grad bei Gasnutzung - Perfekt !Einziges Manko, der Ventilator muss per Tastendruck aktiviert werden bzw. der Modus eingestellt werden. Hier hätte ich mir einen automatischen Modus gewünscht der sofort beginnt wenn Spannung anliegt. Ansonsten Funktionen tadellos

Habe den Lüfter am Wohnwagen Absorberkühlschrank verbaut. Lüfter passen gut, einfach zu verbauen. Leider flackert die LED am Automatik-Modus und die Steuerung gibt auch im ausgeschalteten Zustand ein sehr unangenehmes Pfeifen von sich. Das stört leider sehr, ich weiß noch nicht ob ich den Aufwand betreibe und ihn wieder ausbaue oder es so hinnehme… im Zweifel die Steuerung nicht im Innenraum verbauen!