Warenkorb

Ihr Warenkorb ist leer

Ihr Warenkorb ist leer

sourcing map 2Stk. Wasserhahngriff, Legierung Universalgriff Ersatz Silberton 69 x 31 x 27mm

Kostenloser Versand ab 25.99€

14.29€

6 .99 6.99€

Auf Lager

Info zu diesem Artikel

  • Geeignet für Ventileinsätze mit 8 mm Durchmesser und 20 Zähnen. Geeignet für Verschraubungshöhe 20 mm.
  • Hergestellt aus legiertem Material, langlebig und hochfest.
  • Ausgestattet mit Befestigungsschrauben für eine einfache Installation.
  • Weit verbreitet in Küche, Waschbecken, Badewanne und Bad.
  • Der klassische Stil eignet sich für die Erneuerung oder den Austausch Ihrer Beschläge.


Passend für 8mm Durchmesser und 20 Zähne Ventileinsatz.
Hergestellt aus Legierung, langlebig und hohe Festigkeit.
Ausgestattet mit Montageschrauben für eine einfache Installation.
Weit verbreitet in Küchen, Badewannen und Badezimmern.
Der klassische Stil ist geeignet für die Aktualisierung oder den Ersatz Ihrer Hardware.
Spezifikation:
Material: Legierung
Finish: Galvanik
Passend für Ventilkerndurchmesser: 8mm
Gesamtgröße (ca.): 69 x 31 x 27mm / 2,71" x 1,22" x 1,06" (L*H*Basisdurchmesser)
Innendurchmesser: 26mm / 1,02"

Lieferumfang:
2 x Wasserhahngriff


Customer
Bewertet in Großbritannien am 24. Februar 2025
Out of two sets of taps one had the drive too big and just spun. One is very loose and I'm not sure how long it will last. Other two are ok but I'm not sure how long they will last. Given up and going to buy complete new taps.Not good enough.
Kunde
Bewertet in Deutschland am 5. November 2024
Haben leider nicht auf normalen Wasserhahn gepaßt.....gingen wieder zurück.
Gérard MARCHAIS
Bewertet in Frankreich am 2. November 2024
pratique , mais n'est pas adapté au robinet douche , car l'intérieur est carré , merci...
Crusty
Bewertet in Großbritannien am 30. Juli 2023
Poorly moulded almost non-existent splines on the internal casting hence too large. Bought to fit bath filler, but does not grip shaft. May try packing out with waterproof tape wrapped around splines on top of ceramic cartridge, but will probably slip and wear off what little splines there are, and likely damage the cartridge “male” splines as well. Have tried to fit it on two or three different standard cartridges; IMO this product at fault (oversize, due to lack of meaningful splines). Far more play than 8.2 mm on 8 mm shaft would suggest. More like 1mm+. Pity, as otherwise seems ok. I do have a heavy duty outside tap with no handwheel, so may drill out centre of this to fit that larger shaft, and hammer it on.... may as well use it for something... fishing weight maybe!
candlestrobe
Bewertet in Großbritannien am 15. Oktober 2023
Amazon. You shouldn't be selling these. Poor quality, with thin dented bases and as other reviewers have said the sizing and mechanics of the holding teeth is way off. Shoddy and pathetic copies. Shame on you Amazon.
Harry
Bewertet in Großbritannien am 12. Oktober 2022
Would have been better if one tap had hot or red on top and the other one had blue or cold on top they have neither and there’s no way that I can actually label any of the taps as hot or cold.
Produktempfehlungen

56.99€

28 .99 28.99€

4.4
Option wählen

53.02€

25 .99 25.99€

4.4
Option wählen

28.49€

11 .99 11.99€

4.4
Option wählen

44.39€

19 .99 19.99€

4.3
Option wählen

12.80€

6 .99 6.99€

4.5
Option wählen

18.90€

7 .99 7.99€

4.5
Option wählen