Ihr Warenkorb ist leer
Ihr Warenkorb ist leerSINGMATOOLS Baitcasting Reel Drag Clicker mit Kohlefaser-Zugscheibe, kompatibel mit Shimano Reel Curado DC, 21 Scorp.DC, 19 Scorp. MGL Upgrade-Zubehör Rutenbau Angelrolle Wartung Werkzeug-Set Ersatzteile für Barsch Angelausrüstung
James Plake
Bewertet in den USA am20. Januar 2025
Installed on a '21 Scorpion DC 151 HG. Installation wasn't hard. Just make sure you work in a clean space and keep track of where everything goes. Saw another review that said it took up too much space and they couldn't get the cover back on. I didn't run into any such issues. it comes with a few sizes of washers/shims in case its thicker or thinner tan the original setup. In my case I needed to go thinner. I ended up swapping the 2 copper washers on either side of a bearing out for one 0.2mm and one 0.3mm washer to get the drag feeling right. It gets both looser and tighter than I'll ever need it now.
Shamsuri
Bewertet in Singapur am 11. November 2024
Easy to install. 👍
jamesolayan
Bewertet in Kanada am 21. September 2023
Die Medien konnten nicht geladen werden.
Amazing Customer
Bewertet in den USA am15. Juli 2023
It was easy to install. Sounds great. Instructions are clear enough. Good pictures. Shimano should have included this from the factory.
Lynn
Bewertet in den USA am12. Juli 2023
I installed this in a 21 Shimano Scorpion DC, which it advertises as fitting. I followed the instructions, installation was pretty straightforward. But, the issue is the drag clicker and washer are much thicker than the original parts they are taking place of, which throws off the tolerances between the gears my brand new smooth reel feel very rough. If I take the drag clicker out and install the original drag washer and plate, everything is back to being smooth. Put the clicker back in, and it’s rough again. It’s noticeably harder to get the side cover on with the drag clicker installed, it takes some extra pressure to squeeze it together and I think that’s what’s throwing off the gears just slightly.Unfortunately, once the clicker ring is installed into the main gear, it’s virtually impossible to remove, as it is press fit extremely tightly. You can still convert it back to factory without the clicker, but that one extra piece will still be in there. It doesn’t cause any issues, but, it means I can’t return it.
Produktempfehlungen
26.86€
12 .99 € 12.99€