Ihr Warenkorb ist leer
Ihr Warenkorb ist leer
Diese wurden unter Verwendung eines Marken-3D-Druckers mit PLA-Kunststoff hergestellt. Grundierung kann erforderlich sein, damit die Farbe richtig haftet.
Hergestellt in Großbritannien.
** Diese Modelle wurden von Iain Lovecraft entworfen und von Quality Printing 3D Ltd. für QP3D Wargames unter den Bedingungen einer kommerziellen Lizenz hergestellt.
Customer Review
Bewertet in Großbritannien am 13. Mai 2025
The model comes in three parts, ground floor, first floor and the roof/tower part. Assembly is pretty easy, each part just rests on the part below so you can glue and just leave it to set with no problems. However, for painting I would probably leave it unassembled and paint each part before putting together. There aren't any instructions but its very self explanatory and you could rotate the middle and top if you had multiple of the same tower.The print itself is pretty good quality. Its been cleaned very well, no stands or remnants of stands (if there is some left on you can find little bits sticking out, they are easy to cut off though). Up close you can see a lot of print lines on the cobble stones but you arent going to see that when its on the table/on display unless you get right up to it. What I would say is that the internal walls of the tower don't have any detail which is a bit of a miss and there are some minor defects from the print process. Fortunately as it's a ruined tower it just adds a little bit of extra 'wear' to the model.There are a number of small holes on the corner pieces of each of the three parts. I suspect these are supposed to be guides for assembly or pre-drilled holes if you want to pin the parts together, or if you want to add pegs so you can take it apart (for example if you want to put models inside). Either way you can fill them with 'green stuff' if you want to hide them).Scale wise its pretty good. I put a 28mm model and a 32mm model and the they look like they fit well. They feel like they could go through the towers door.Its a pretty great 3D Print Kit, although price dependent. If its going for around... £20-£30 Id say thats a fair price (and would be cheaper than a hard plastic kit). If its pushing £40+ id maybe expect more. At the price of £22 it's good value.I hope you found this review useful.If you have a question, I always try to respond when Amazon forwards them to me.
Sleepy Bear
Bewertet in Großbritannien am 10. Mai 2025
The model came well packaged and protected from damage in transit. It has been well made with a good finish and has excellent detail. It’s a great size for making dioramas, which is what I wanted it for. There is a lot to paint on it and I can’t wait to get started! Now that I’ve discovered this good brand, I will definitely be buying more from their range and am happy to recommend the product.
Produktempfehlungen
64.74€
27 .99 € 27.99€
45.00€
21 .99 € 21.99€