Ihr Warenkorb ist leer
Ihr Warenkorb ist leerEinzigartiges Design ermöglicht es Holzarbeitern, Zapfen jeder Länge für extra starke Gelenke zu produzieren. Oberfräsen-Bit-Set. Anwendung: Erstellen Sie individuelle Full Lite oder True Divided Lite französische Türen in jeder Größe und mit jeder beliebigen Holzart. Hergestellt in Italien.
D. Robert
Bewertet in den USA am9. Dezember 2024
These bits worked perfectly! They are super sharp and cut so clean that there was almost no sanding required. I'm very happy with this purchase. Our new interior doors turned out beautiful!!
SJ
Bewertet in den USA am15. Dezember 2024
Works well
ANA PATRICIA ROBLES LINARES
Bewertet in Mexiko am 10. September 2019
Excelente calidad muy recomendable.
Mitch Leonard
Bewertet in Kanada am 14. November 2018
Obviously these things rock. Freud makes quality products. Very precise. Comes in cheap plastic. This is really about the router bits
Isaac Moore
Bewertet in den USA am25. März 2011
I used these bits to route a profile on a 5" high square base frame for a rotating bookshelf. I started with planed stock in both width and thickness. It was imperative to have stock that was the same width to allow the profiles to line up once the ends were mitred. Before each pass, I adjusted the fence and feather boards. It was very important to use double feather boards on the table and to have two f/b's attached to the table's fence. With this setup, I only had to push the boards from the end...no hand support around the bit. The finished product was very good. I had minor areas where the two bits left a line, but it was easily sanded out, even though I was using curly maple. I did get a little chatter 3-4" on the ends of the boards, but these were offcut when mitreing.BTW, Woodcraft has examples of routed profiles in their stores under the display. That is how I decided on which bit set to choose. Happy routing.
Produktempfehlungen
48.16€
23 .99 € 23.99€
33.99€
17 .99 € 17.99€
92.63€
43 .99 € 43.99€