Schnelle und gut verpackte Lieferung, zügig geladen und angebracht in einer dunklen Abstellecke - einwandfrei, super praktisch, haften bisher prima. Durch den Magnet ist sie auch schnell mal flexibel woanders nutzbar, sehen hochwertig aus, pfiffige Helfer, möchte sie nicht mehr missen :-)

Ich habe die EZVALO Unterbauleuchten für meine Küche bestellt, da ich eine kabellose und flexible Beleuchtungslösung suchte. Nach mehreren Wochen Nutzung hier meine Erfahrungen:Positives:✔ Helles & angenehmes Licht – Die 80 LEDs pro Leuchte sorgen für eine gleichmäßige Ausleuchtung. Die drei Farbmodi (Warmweiß, Neutralweiß, Kaltweiß) sind praktisch für verschiedene Stimmungen.✔ Einfache Montage – Dank der magnetischen Halterung lassen sich die Leuchten problemlos anbringen und bei Bedarf abnehmen.✔ Bewegungsmelder funktioniert zuverlässig – Besonders in Schränken oder dunklen Ecken reagiert der Sensor schnell und schaltet das Licht automatisch ein.✔ Wiederaufladbar per USB – Kein Kabelsalat oder Batteriewechsel nötig. Der Akku hält je nach Nutzung mehrere Tage bis Wochen.✔ Dimmfunktion – Die Helligkeit lässt sich je nach Bedarf anpassen, was gerade abends angenehm ist.Negatives:➖ Bewegungssensor manchmal zu empfindlich – Er schaltet sich manchmal ein, wenn ich nur in der Nähe vorbeigehe, selbst wenn ich ihn nicht direkt benötige.➖ Akku könnte länger halten – Bei intensiver Nutzung muss er öfter geladen werden, was etwas umständlich ist.Fazit:Die EZVALO Unterbauleuchten sind eine praktische, moderne und vielseitige Beleuchtungslösung für Küche, Schränke oder dunkle Ecken. Sie lassen sich leicht anbringen, bieten verschiedene Lichtmodi und reagieren gut auf Bewegung. Wer eine kabellose Alternative zu herkömmlichen LED-Leisten sucht, macht mit diesem Set nichts falsch.⭐⭐⭐⭐☆ (4,5/5 Sterne)

Great for lighting up dark areas. I mainly use it on the auto setting in the bathroom and one in the kitchen. The charge lasts an impressive time. Easy to remove off the very strong magnet and charges quickly. Great for closets too.

Einfach zu montieren, 3 Lichtstufen sind gut abgestimmtMir fehlt die Einstellung der Dauer der Beleuchtung....

Die Lampen sind wunderschön und ein sehr guter Helfer. Ich habe sie mir in den Flur und im Schlafzimmer angebracht. Sie leuchten wunderbar in der Dunkelheit, und die stufenweise Einstellung des Lichts ist perfekt, um sich in der Nacht, im Dunkeln sicher zu bewegen. Man muss somit kein anderes, helles Licht einschalten. Solche Leuchten sollten stets in einer Wohnung oder in einem Haus mit eingeplant werden, gerade für die ältere Generation oder aber auch für die Kinder, wenn diese nachts einmal raus müssen und, um dann zufrieden wieder ins Bett gehen zu können, ohne vom grellen Oberlicht gestört zu werden.

Die Lampen sind super, halten was sie versprechen. Ausreichend hell, gute Einstellmöglichkeiten von warm bis Kaltlicht und Helligkeitsstufen. Radius vom Bewegungsmelder ist ebenfalls sehr gut.Kann die Lampen nur empfehlen.

Die Leuchte hängt magnetisch an 2 Haltern, die angeklebt werden. Das funktioniert gut. Die Näherungssensoren, die die Leuchten ein- aund ausschalten, tun ebenfalls ihren Job. Ich nutze sie an einem Plattenregal, was sehr gut funktioniert.

Prompte Funktion, Magnetbefestigung am Metallgeländer, Farbtemperatur und Helligkeit einstellbar. Ca 1 Monat bis zum nächsten Aufladen. Sehr Preiswert.

We live off-grid. So I limit myself on lighting. These lights work great. Have one over my kichen stove and another lower down on a cabinet. Motion sensor is great when walking by.

love these lights

I've used and reviewed many different types and brands of rechargeable motion-sensor LED lights, this one is a alternate color option (gun metal gray) for another silver one I reviewed recently. As is the case with the silver model, this design and interface may be the best I've seen.I own several EZVALO lights and they've made significant improvements with the newer models, mostly related to the user interface and overall ease of set up. On some lesser lights I've used the interface isn't really user intuitive and can get confusing.As is the case with similar EZVALO lights, there are three simple controls on the face of the light. These are identical to the silver version.1) The slider has four settings: always on, night sensing mode, day sensing mode, and off. These are easy to see and to use. Selecting the sun icon (day sensing) means that the sensor will respond regardless of the level of ambient light. Selecting the moon icon (night sensing) means the light will come on only when there is no ambient light. This is a great feature because your needs may vary depending on where you install the light (e.g., under a counter versus in a dark closet). I believe that trial and error based on the location works best.2) The top button next to the sensor adjusts the light level, using three presets. I always select the one that works best for the location. Some lights sometimes have a button that you must hold down to adjust the light. I prefer presets because it's easier to set a consistent level. If you have more than one this is useful if you want them to match.3) The bottom button controls the color temperature: warm, natural, and cool. I think that this setting is crucial because different color temperature settings may be the better in different situations. Above a counter I like warm, but inside a closet or cabinet I prefer natural. I only use the cool setting in my garage.This light has two embedded magnets. I do not like lights that come with self-adhesive magnets: these never seem to stick very well and often fall off. Lights that have embedded magnets can be attached to any metal surface.Two self-adhesive metal plates are supplied, which you affix where you want to install the light. The EZVALO plates are great because they have a raised lip on each of the sides that run parallel to the light. These lips help hold the light in place.Like other EZVALO lights, installation of this light is easier because the locations of the embedded magnets are marked on the bottom of the light. I always place the magnets on the marked area and peel the cover off the adhesive side of the plate without shifting the magnet. I then press the light into place where I want it installed and carefully pull the light off the plates, leaving the plates attached. Next I always remove the light and press on the plates to make sure the adhesive has fully adhered.This light is USB rechargeable, as is standard: In my view there is no reason to buys lights that use traditional (or even rechargeable) AAA or AA batteries. Recharging usually takes 1-2 hours. I especially like that there are indicator lights next to the USB port: red = low battery, green = fully charged.This is a premium light in my book because the battery has a higher mAh rating (3200 versus 1900 on some lights). This means that you'll need to recharge it less frequently. Also, this light has a higher number of LEDs (134 versus 80 on some lights).This is an excellent light with a great design: Highly recommended.

Grundsätzlich ganz cooles Produkt. Viele Möglichkeiten der Farb- und Lichtstärkeeinstellungen. Das hellste Licht ist wirklich sehr hell und ausgebreitet. Sensor funktioniert von weiterer Entfernung schon und schaltet das Licht ein (noch bevor man direkt davor steht) . Montage ganz simple, haltet auch bis jetzt (2 Wochen) einwandfrei. Der Preis ist es Wert!Einziger Minuspunkt:Habe sie in der Küche ober der Arbeitsplatte picken, bei jeder Bewegung oder Eintritt in den Raum, gehen diese an. Infolgedessen muss ich sie jeden 2 Tag zum Laden anstecken. Ein wenig mühsam.

Having used and reviewed many different brands of rechargeable motion-sensor LED lights, this one may be the best I've seen.I own several EZVALO lights and the improvements in the newer models released this year have been significant, mostly related to the user interface and setting up the controls. On some lights setting the various modes can be confusing and are not particularly user-intuitive.As with similar EZVALO lights, there are three controls on the face of the light.1) Slider: The slider has four settings: always on, night sensing mode, day sensing mode, and off. These are easy to see and to use. Select the sun icon (day sensing) if you want the sensor to respond regardless of the level of ambient light. Select the moon icon (night sensing) if you only want the light to come on when there is no ambient light. Having this choice is an excellent feature because your needs will vary depending on where you place the light (say under a counter versus in a dark closet). Trial and error based on the location works best.2) The top button next to the sensor adjusts the light level. There are three presets: Select the one that works best for the location. Similar lights sometimes have a button that you must hold down to adjust the light. I believe having presets is better because it's easier to select a consistent level. This is useful if you have more than one (so they'll match).3) The bottom button controls the color temperature: warm, natural, and cool. In my view this setting is very important because each color temperature setting may be the best in different situations. I like warm above a counter, but inside a closet or cabinet I prefer natural. I only use the cool setting in my garage.This light has embedded magnets, which I believe is the best design. I do not like lights that have self-adhesive magnets: these never seem to stick very well and often fall off. Lights that have embedded magnets can be attached to any metal surface.Two self-adhesive metal plates are supplied, which are placed where you want to install the light. The EZVALO plates have a raised lip on each of the sides that run parallel to the light. I prefer this design because it helps hold the light in place.The locations of the embedded magnets are marked on the bottom of the light: This makes installation a little easier. The best way to install this light is to place the magnets on the marked area and peel the cover off the adhesive side of the plate without shifting the magnet. Then you press the light into place where you want it installed and carefully pull the light off the plates, leaving the plates attached. Next just remove the light and press on the plates to make sure the adhesive has fully adhered.As is standard, this light is USB rechargeable; recharging usually takes 1-2 hours. I especially like that there are indicator lights next to the USB port: red = low battery, green = fully charged.What makes this light premium in my book is that the battery has a higher mAh rating (3200 versus 1900 on some lights). This means that you'll need to recharge it less frequently. Also, this light has a higher number of LEDs (138 versus 80 on some lights).This is an excellent light with a great design: Highly recommended.