Ihr Warenkorb ist leer
Ihr Warenkorb ist leerDIN-Schienenhalterung für Arduino UNO R3 / Mega 2560
Martin Rasch
Bewertet in Deutschland am 6. Februar 2025
Passt wie erwartet für Arduino
Jan Kaliciak
Bewertet in Großbritannien am 11. Oktober 2021
This is a neat solution for accommodating an ARDUINO MEGA 2560 Rev3 and cloned variants on DIN rail systems.It is simple enough to attach the Mega 2560 to the carrier mount, but not with the supplied bolts....which risk crunching PCB components....as their heads are too large to fit between some items on the board.They are not self-tapping screws, just ordinary threaded bolts which are hard to screw into the plastic holes, which in the long run would wear away the bore. Best not to even go there.The solution was to use six M2 10mm bolts, with washers and nuts, which makes a perfectly secure fit, sliding through without damage to the mounting....and more importantly, the heads safely clearing all PCB components.More disconcerting was the vertical wobble, even if the Mega 2560 is not fitted with a shield. The mount does not sit quite vertical. If the foot in contact with the rail was twice as wide on the facing (Mega) side, then this may have mitigated this discrepancy.Packing the mount's sides with other solidly fitting standard DIN components did not help much to stabilise the mount....it may require these to be directly superglued to the mounting plate, to meet stability requirements for installation in mobile devices.There are some well considered anchors on the mount, with some thoughtfully provided cable-ties for binding USB and Power input lines in situ.It is expensive for what it is, and somewhat lacking the usual locked-in precision of DIN accessories.
Gandolfo
Bewertet in Italien am 17. September 2020
L'ho preso per montare arduino uno su barra din. Le dimensioni sono giuste per arduino e si monta facilmente, unico appunto forse è la platica a mio avviso non molto resistente ma finora non ho avuto problemi. COnsigliato se volete montare arduino su barra din.
Carlos T.
Bewertet in den USA am31. Oktober 2019
Great!
davel
Bewertet in den USA am29. November 2019
DIN mounted components make DIY projects easy to prototype and are very rugged at the same time. The DIN rail mount for the Arduino UNO fit right into the rest of my project. However, I also added a terminal breakout board which expanded the size of my UNO. The terminal board provided rugged screw-in terminal connections but at the cost of the 5V and GND wires (on the bottom) nearly touching the metal DIN rail. A 2nd set of hole mounts or a groove cut out would be a nice feature. This would permit adjustment of the UNO in order to allow more clearance for wiring. I also sawed off the cable holders. (-1 star). Recommend the 3-pack (edited -- just saw them listed) -- handy for modifying software and swapping in/out of the hardware project. I am purchasing more of these.
ThatOneGuy
Bewertet in den USA am1. Januar 2019
Have you ever needed to mount an Arduino to a DIN rail? I have, and this product made it happen! This was a great and inexpensive solution that worked flawlessly! Five Stars!
Produktempfehlungen
