Ihr Warenkorb ist leer
Ihr Warenkorb ist leerMerkmal:
1. Optischer Isolationssignaleingang.
2. Ausgangsstrom-DIP-Schalter ist einstellbar.
3. Bipolare Konstantstrom-Zerkleinerungsmethode.
4.Hohe Segmentierung:2,4,8,16,32,64,128,256 5,10,25,50,125,200;
5. TTL-Eingangssignal kompatibel, während Differenzsignal-Eingang akzeptiert wird.
Bhavesh Panchal
Bewertet in Indien am 18. November 2024
Good reliable Product. Value for money
stuart dean
Bewertet in Großbritannien am 14. Juli 2024
Excellent value for money CNC is working well
Alastair G. Stell
Bewertet in den USA am9. Oktober 2023
Though listed as a CNC microstep controller, I bought this to use on my personal electronics project. I cannot attest to its effective on CNC machines but for my application it works perfectly. I recommend looking up the online manual for this controller as the printing on the case does not list all settings - including the holding torque which can be modified via one of the dip switches.The input controls are pulse, enable and direction. There are specific timing requirements for this controller, especially where changing direction is concerned. Again, consult the manual if you are using this controller for your own project - the timing is important!One point to note. The Enable input can usually be left open circuit (the inputs are isolating optocouplers). I expected that you enable the controller by powering the Enable input (turning on the optocoupler). However this is incorrect. Activating the Enable has the effect of disabling the controller and causes the 'error' led to turn on solid.In my application I am driving a 3 Amp stepper motor, at 24V, from my raspberry pi. I use a common positive to the 3 inputs and buffer the pi (which outputs 3.3V) with a pull-low transistor (and base resistor) on each individual input. Works like a charm.Hope this helps! Overall a very nice, easy to use, controller.
Žan
Bewertet in Deutschland am 3. Januar 2023
everything works great.
Quäntchen
Bewertet in Deutschland am 25. Dezember 2023
Der Treiber funktioniert soweit gut.
A.Rian
Bewertet in den Niederlanden am 21. Oktober 2022
ik heb twee van "DM542 Stepper Motor Driver Controller" betaald. ik heb alleen 1x ontvangen.
armax62
Bewertet in Italien am 18. Februar 2022
Acquistati per un nuovo drive.molto soddisfatto, li avevo da almeno 7anni su un altra CNC, si confermano dei driver affidabili ed economici.
Hartmut Eger
Bewertet in Deutschland am 31. Oktober 2021
Alles Perfekt, schnelle Lieferung. Gerne wieder
Produktempfehlungen
18.76€
9 .99 € 9.99€
46.42€
24 .99 € 24.99€
29.99€
13 .99 € 13.99€