Ihr Warenkorb ist leer
Ihr Warenkorb ist leerAOSK Aufkleber für Mustang Mach e Mittelkonsole, kompatibel mit Mustang Mach-E 2021–2024 (matte Kohlefaser)
Christian Krastev
Bewertet in Deutschland am 4. März 2025
Past perfect
oscar
Bewertet in den USA am13. Juni 2025
Envío rápido, queda perfecto 👌 color mate .
A. Kintz
Bewertet in den USA am23. September 2024
I'm really not one for stick on interior accents - many of them just come across cheap and tacky. But in this case I really wanted something to cover up the gloss black trim on the center console. And the matte carbon looked like it should do that job pretty well... and once I saw the center console, I picked up the door switch trim too.CENTER CONSOLEOverall, I actually like these bits more than I thought I might. Sure, it's not real carbon - but I'll live. It does it's job and adds to the overall look of the interior. I'm not at all bothered by the small gap underneath the gear selector (but it is there, as you can see in my photo and the other review with it). I'm a little surprised there's such a gap but it's at least in a place I'm never going to look at and have to TRY to see.Installation was a little more tricky than I had thought at first. You can't just put the part down into place and call it a day. I had to sort of wedge it in from the driver's side first. I started by fitting the gear selector section into place and then rotated the whole thing clockwise from there to get the front into place. Not ideal, but it seemed to work (I was minutes away from contacting AOSK for support). Once I figured that out and confirmed my test fit, I fully peeled the front and back adhesive but only partially pulled the side strips (maybe 1.5" from the back?). I gave the console an alcohol wipe and wedged it into place. I was able to line everything up pretty well and then press the front and back adhesive down. Then I could pull the strips off the sides as I kept it aligned with the inside edge.Yes, you can sort of see a little edge of the existing console - but it looks fine. Zero complaints about the fit, other than around the gear selector console, like mentioned above.However, one other note: I also have the BestEVMod ABS center console tray (https://www.amazon.com/dp/B09M3J1568). I removed this to install the trim cover and put it back. It is now very slightly "loose" and moves a little forward and backward. I think it's just because it sits up a tiny bit higher now and isn't as tight down in the main console since it sits on a little lip the organizer tray has. I'll figure out my own fix to that, but worth noting if you have similar parts. I also have the rubbery console organizer (https://www.amazon.com/dp/B09QC7HGVQ) and that fits fine with the trim cover since there's no upper lip.DOOR SWITCH PANELSI bought these after I installed the console trim. I wanted something else to match that new interior design. These are basically of the same quality (not real carbon, duh, but decent ABS with what looks like 3M VHB adhesive).Two things on the adhesive though - one of them was different than the others (gray vs clear). Didn't seem to matter overall, but we'll see in time. Secondly, the adhesive on the right rear part was a little overlapped and the red seal on the adhesive had already started to separate in one of the spots with some tension. Again - it didn't APPEAR to be an issue for the install, but time will tell.Fit was good overall - except for the left rear door. I think this part could be a little wider. I think my alignment was really good but there's a small gap on the right side that probably should be filled. I'm never going to look at it from the driver's seat - but I KNOW IT'S THERE.Overall - both of the things I bought seemed like they were good parts. A couple minor issues here and there with fit and adhesive, but I'd still recommend them. I would like to see some cheap alcohol wipes included for prepping the surfaces though. I already have some, but I think they could be useful.
Marc B.
Bewertet in Kanada am 17. September 2024
The carbon fiber looks good but the fit is awful with gaps. Looks worse with product installed than before installing because fit. Would not recommend, not worth what they are charging.
Heinz Georg Brandl
Bewertet in Deutschland am 12. März 2023
Das Teil hat meine Erwartungen voll erfüllt Passform ist klasse
A jones
Bewertet in Kanada am 29. September 2022
The fit was good. Just didn’t like the imitation carbon fibre pattern. It didn’t match close enough to the factory look for me. Maybe I’m just picky, but it is a $80K car so.
Peter Hartland
Bewertet in Großbritannien am 23. November 2022
Fits almost like a glove have to look very carefully to see it ia an after market item. Matches the Carbon effect of the dash & takes away that black gloss finish & stops any scratches.
Produktempfehlungen