Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktinformation
T3100 Hochspannungs Sonde (100MHz)
- Abschwächung: 1:100 ;
- Eingangswiderstand:100MΩ ;
- Eingangskapazität: X100: 14.5pF~17.5pF ;
- Kompensationsbereich: 15pF~35pF ;
- Systembandbreite: DC~100MHz ;
- Maximale Arbeitseingangs Spannung: X100: <2000VDC+Peak AC ;
- Temperatur Betrieb Nichtbetrieb: -10℃--+50℃ -20℃--+75℃ ;
- Luftfeuchtigkeit: ≤85% (Relative Luftfeuchtigkeit);
Circuit Bug
Bewertet in den USA am16. März 2024
I needed to observe a higher voltage pulse above 200V and my scope wouldn't handle it, but this probe made it possible. I think it's a good price for the probe, and it works well and seems to be of good quality and comparable to other probes I have used from several different makers. I don't have a good way to check accuracy, but results are reasonable and I'm not inclined to mark it down just because I can't test accuracy.
BK
Bewertet in den USA am11. Juli 2023
So didn't notice till it arrived and started using it.. The ground leads is not removable, so there by not repairable once it finally breaks.Not if, but when. If you've used scopes long enough, than you know.The hat hook is made well , the rest of the probe feels well made.. but the non-removable ground is a deal breaker, wont buy another.I bought this while I was waiting for another brand to arrive, where I buy direct from the manufacture who only deals with making probes, but it takes a week. Needed the x100 now.
Paul Richer
Bewertet in Kanada am 25. Februar 2022
Because 100:1 ratio is fixed (no switch), an alternative source to standard scope 3V square test signal must be provided to calibrate. But the absence of switch makes it a bit more rugged.As usual, great Hantek price/quality ratio.I always seen the old ground wire that clips to the probe as a big flaw. I'm not sure if permanent ground it's just for the high voltage model or for new models, and hope for the latter.
Anon
Bewertet in Kanada am 28. Oktober 2020
Good value for money, build quality was much higher than the other budget-oriented X100 high voltage probes I've tried out!
John
Bewertet in Kanada am 16. Oktober 2015
These probes need to be certified CE, UL or CSA approved. They need to be at least CAT III rated. They are not.Using these probes could be fatal and can not be used in Canada per the CSA 462 Standard for Electrical Safety.Do not buy these probes. I am certain that people will buy them anyway and use them because they are inexpensive, however many electrical systems have very high arc flash levels. If these probes fail while you are holding them in your hand, you may not have any skin left on your face and arms. THINK about it.
Produktempfehlungen